Hiland HLDS032-B

Інструкцыя па эксплуатацыі партатыўнага настольнага абагравальніка для паціа Hiland HLDS032-B

Model: HLDS032-B

1. Уводзіны

This manual provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your Hiland HLDS032-B Portable Table Top Patio Heater. Please read all instructions carefully before use and retain this manual for future reference.

The Hiland HLDS032-B is a compact, portable propane-fueled heater designed for outdoor use, providing 11,000 BTUs of heat. It is suitable for placement on tabletops and can operate with either a 1lb propane tank or a 20lb propane tank (with an adapter hose, not included).

Hiland HLDS032-B Portable Table Top Patio Heater in stainless steel finish.
Image: The Hiland HLDS032-B Portable Table Top Patio Heater, showcasinдзякуючы аздабленню з нержавеючай сталі і кампактнаму дызайну.

2. Інфармацыя па бяспецы

WARNING: For Outdoor Use Only. Do not operate this heater indoors or in enclosed spaces.

  • Always ensure adequate ventilation when operating the heater.
  • Keep clear of combustible materials. Maintain a minimum clearance of 24 inches (61 cm) from sides and rear, and 36 inches (91 cm) from the top.
  • Гэты абагравальнік абсталяваны thermocouple and anti-tilt safety devices, which will automatically shut off the gas supply if the pilot flame extinguishes or the unit tips over.
  • Не захоўвайце і не выкарыстоўвайце бензін або іншыя лёгкаўзгаральныя пары і вадкасці паблізу гэтага або любога іншага прыбора.
  • Propane gas is heavier than air and will settle in low areas. Ensure the area around the heater is clear of any potential ignition sources.
  • Always inspect the gas hose and connections for leaks before each use. Use a soapy water solution to check for bubbles.
  • Do not attempt to repair or alter the heater. Contact qualified service personnel for repairs.
  • Трымайце дзяцей і хатніх жывёл далей ад абагравальніка падчас працы.
  • Гэты прадукт утрымлівае хімічныя рэчывы, якія, як вядома ў штаце Каліфорнія, выклікаюць рак і прыроджаныя дэфекты або іншыя парушэнні рэпрадуктыўнай функцыі (папярэджанне Прапановы 65).

3. Змесціва ўпакоўкі

Verify that all components are present and undamaged before assembly. If any parts are missing or damaged, do not proceed with assembly; contact customer service.

  • Heater Head Assembly (Burner, Reflector, Screen Guard)
  • Асноўны корпус/корпус
  • Апорная пліта
  • Heavy Weight Plate for Stability
  • Рэгулятар
  • Hardware Pack (screws, wrench)
  • Кіраўніцтва па эксплуатацыі

4. Зборка і ўстаноўка

Follow these steps for proper assembly and initial setup of your patio heater.

4.1 Attaching the Base and Weight Plate

  1. Акуратна распакуйце ўсе кампаненты.
  2. Attach the heavy weight plate to the underside of the base plate using the provided hardware. This plate significantly enhances stability.
  3. Secure the main body/housing to the base plate.
Ніжні бок view of the heater base showing the heavy weight plate attached for stability.
Image: Underside of the heater base with the heavy weight plate installed. This plate adds crucial stability to the unit.

4.2 Installing the Propane Tank

The heater is designed to use a 1lb propane tank directly or a 20lb propane tank with an optional adapter hose (not included).

  1. Пераканайцеся, што ручка кіравання знаходзіцца ў становішчы «ВЫКЛ».
  2. Open the access door on the main body of the heater. This door provides easy access to the propane connection point.
  3. Connect the regulator to the propane tank. For a 1lb tank, screw it directly into the regulator. For a 20lb tank, connect the adapter hose to the tank and then to the regulator.
  4. Carefully place the propane tank inside the heater's housing. The regulator may tilt for easier installation.
  5. Надзейна зачыніце дзверы доступу.
Close-up of the heater's main body showing the open access door for propane tank installation.
Image: The access door on the heater's body, designed for convenient installation of the propane tank.
Close-up showing a 1lb propane tank being installed into the heater with the tilting regulator.
Image: A 1lb propane tank being connected to the tilting regulator inside the heater's housing.
Інтэр'ер view of the heater showing the propane connection point.
Выява: Унутраная view of the heater's base, illustrating the propane connection point for the tank.

4.3 Праверка на герметычнасць

Перад першым выкарыстаннем і пасля кожнай замены бака правядзіце праверку на герметычнасць:

  1. Mix a solution of soapy water (50% soap, 50% water).
  2. Ensure the heater's control knob is OFF.
  3. Адкрыйце кран бака з пропанам.
  4. Apply the soapy solution to all gas connections. If bubbles appear, there is a leak. Tighten connections or replace parts as necessary. Do not operate the heater if a leak is detected.

5. Інструкцыя па эксплуатацыі

This section details how to safely ignite and operate your Hiland patio heater.

5.1 Працэдура запальвання

It is recommended to perform the initial ignition in low light conditions to clearly see the pilot flame.

  1. Пераканайцеся, што клапан пропан-балона цалкам адкрыты.
  2. Push in the control knob and rotate it counter-clockwise to the "PILOT" position.
  3. While holding the knob in, press the red igniter button repeatedly until the pilot flame ignites. You may need to press it multiple times (up to 15-20 times) until you hear a click and see the pilot light.
  4. Once the pilot is lit, continue to hold the control knob in for at least 15-20 seconds. This allows the thermocouple to heat up and engage the safety valve. Releasing too soon will cause the pilot to extinguish.
  5. After holding, slowly release the control knob. The pilot flame should remain lit. If it extinguishes, repeat steps 2-4.
  6. To ignite the main burner, push in the control knob and rotate it further counter-clockwise to the "LOW" or "HIGH" position. The main burner should ignite.
Close-up of the control panel with the black control knob and red igniter button.
Image: The control knob and igniter button on the heater's body, used for starting and adjusting the flame.
Close-up of the protective heat screen surrounding the burner element.
Image: The protective heat screen, designed to prevent direct contact with the hot burner element during operation.

5.2 Adjusting Heat Output

Rotate the control knob between "LOW" and "HIGH" to adjust the heat intensity as desired. The heater provides up to 11,000 BTUs of heat.

5.3 Выключэнне абагравальніка

  1. Rotate the control knob clockwise to the "OFF" position.
  2. Зачыніце клапан на балоне з пропанам.
  3. Дайце абагравальніку цалкам астыць, перш чым перамяшчаць або захоўваць.

6. Тэхнічнае абслугоўванне

Рэгулярнае тэхнічнае абслугоўванне забяспечвае бяспечную і эфектыўную працу вашага абагравальніка.

  • Уборка: Працярыце вонкавыя паверхні мяккай, damp cloth. Do not use abrasive cleaners or solvents. Ensure the burner screen is free of debris.
  • захоўванне: When not in use for extended periods, disconnect the propane tank and store the heater in a dry, protected area.
  • Інспекцыі: Periodically check all gas connections and the hose for signs of wear, damage, or leaks.

7. Выпраўленне непаладак

Звярніцеся да гэтага раздзела, каб даведацца пра распаўсюджаныя праблемы і іх рашэнні.

праблемаМагчымая прычынаРашэнне
Абагравальнік не запальваецца.
  • Propane tank empty or valve closed.
  • Запальная лямпачка не запальваецца.
  • Thermocouple not heated sufficiently.
  • Gas pressure issue.
  • Check propane level and ensure tank valve is fully open.
  • Press igniter button repeatedly. Ensure control knob is held in at "PILOT" position.
  • Hold control knob in at "PILOT" for 15-20 seconds after pilot ignition.
  • Check regulator and hose for kinks or damage.
Pilot light ignites but does not stay lit.
  • Control knob released too soon.
  • Faulty thermocouple.
  • After pilot ignition, hold control knob in for a full 15-20 seconds to allow thermocouple to heat.
  • Contact customer support for thermocouple replacement.
Нізкая цеплааддача.
  • Нізкі ўзровень пропану.
  • Control knob not set to "HIGH".
  • Заменіце або запраўце балон з пропанам.
  • Adjust control knob to desired heat setting.
Пах газу.
  • Уцечка газу.
  • Immediately shut off gas at the tank. Perform a leak test with soapy water. Do not operate until leak is resolved.

8. Тэхнічныя характарыстыкі

Нумар мадэліHLDS032-B
Цеплааддача11,000 BTU
Тып паліваPropane (1lb tank or 20lb tank with adapter)
Памеры (Д x Ш x В)20.87" x 37.8" x 20.87"
ВагаApproximately 1 pound (unit only, without propane tank)
Функцыі бяспекіThermocouple, Anti-Tilt Safety Device, Burner Screen Guard
СертыфікатыЗацверджана CSA

9. Гарантыя і падтрымка

Hiland products include a one-year warranty against manufacturer defects. AZ Patio Heaters LLC maintains a complete line of replacement parts and a full-service repair center.

For warranty claims, replacement parts, or technical support, please contact Hiland customer service. Refer to your purchase documentation for contact details.

© 2023 Hiland. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.