1. Прадукт скончыўсяview
The Sicce Ultrazero Flat Sucking Pump is designed for efficient removal of water from various areas, including flooded cellars, garages, and other spaces where minimal residual water is desired. This submersible pump is capable of reducing water levels down to 2-3 mm.
Асноўныя характарыстыкі:
- Capable of pumping water down to 2 mm residual level.
- Fully submersible design.
- Handles dirt particles up to 3 mm in size.
- Equipped with a 10-meter power cable.
- Features a practical carry handle for easy transport.
Малюнак 1: Закончанаview of the Sicce Ultrazero Flat Sucking Pump.
2. Інфармацыя па бяспецы
Read all safety warnings and instructions before operating the pump. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- Always disconnect the pump from the power supply before handling, cleaning, or performing any maintenance.
- Пераканайцеся, што аб'ём блока харчаванняtage matches the pump's specifications (230 V/50 Hz).
- Do not operate the pump with a damaged power cord or plug. If damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid a hazard.
- Do not use the pump to handle flammable or explosive liquids.
- Трымайце дзяцей і старонніх асоб далей ад зоны эксплуатацыі.
- Падчас працы пераканайцеся, што помпа цалкам пагружаны ў ваду, каб пазбегнуць перагрэву.
- Avoid running the pump dry for extended periods.
- This pump is designed for water only. Do not use it for other liquids without consulting the manufacturer.
3. Настройка і ўстаноўка
Follow these steps to properly set up your Ultrazero pump:
- Распакуйце помпа: Carefully remove the pump and all accessories from the packaging. Inspect for any damage.
- Connect the Discharge Hose:
The pump features a 26.44 mm (3/4") AG pressure connection. Attach a suitable discharge hose (e.g., 20 mm (3/4") hose connection) to this outlet. Ensure the connection is secure to prevent leaks.
Figure 2: Close-up of the pump's discharge outlet and integrated carry handle.
- Размесціце помпа: Place the pump directly on the surface from which water needs to be removed. Ensure the pump is stable and upright. The flat base allows for efficient water removal down to minimal levels.
- Route the Discharge Hose: Direct the discharge hose to a suitable drainage area, ensuring the water will not flow back into the area being drained.
- Падключэнне сілкавання: Plug the 10-meter power cable into a grounded 230 V/50 Hz electrical outlet. Ensure the outlet is protected by a Ground Fault Circuit Interrupter (GFCI) for added safety, especially in wet environments.
Figure 3: The flat base of the pump designed for low residual water levels.
4. Інструкцыя па эксплуатацыі
The Ultrazero pump is designed for simple operation:
- Акуніце помпа: Ensure the pump is fully submerged in the water you wish to remove. The pump requires water to cool its motor and operate correctly.
- Пачаць прапампоўку: Once submerged and connected to power, the pump will begin operating automatically. It does not feature a float switch, so manual monitoring is required for optimal use.
- Манітор ўзроўню вады: The pump will continue to operate until the water level reaches its minimum suction capability of 2-3 mm.
- Stop Pumping: To stop the pump, disconnect it from the power supply. It is recommended to disconnect the pump once the desired water level is reached or if the pump starts to run dry.
Figure 4: The Ultrazero pump effectively draining water from a small pool.
Figure 5: The pump in action on a flooded floor, demonstrating its low-level suction capability.
Figure 6: Illustration of the pump's ability to reduce water levels to approximately 2 mm.
5. Тэхнічнае абслугоўванне
Рэгулярнае тэхнічнае абслугоўванне забяспечвае даўгавечнасць і аптымальную прадукцыйнасць вашага помпы.
- Уборка: After each use, especially when pumping dirty water, rinse the pump thoroughly with clean water. This helps prevent sediment buildup.
- Праверце наяўнасць смецця: Periodically check the pump's intake area for any debris (e.g., leaves, small stones) that might obstruct water flow. Remove any blockages carefully after disconnecting power.
- Праверка кабеля: Regularly inspect the power cable for cuts, abrasions, or other damage. Do not use the pump if the cable is damaged.
- захоўванне: When not in use, store the pump in a clean, dry place, protected from frost.
Figure 7: The pump can also be used for transferring water for tasks like garden watering from a rain barrel.
6. Выпраўленне непаладак
If you encounter issues with your Ultrazero pump, refer to the following common problems and solutions:
| праблема | Магчымая прычына | Рашэнне |
|---|---|---|
| Помпа не запускаецца. | Няма крыніцы харчавання. Кабель сілкавання пашкоджаны. Motor overload protection activated. | Праверце падключэнне сілкавання і разетку. Inspect cable for damage; replace if necessary (by qualified personnel). Disconnect power, allow motor to cool, then reconnect. |
| Помпа працуе, але вада не паступае. | Intake blocked. Discharge hose kinked or blocked. Airlock in pump. | Disconnect power, clear intake. Check and clear discharge hose. Briefly lift and lower the pump while submerged to release trapped air. |
| Reduced pumping performance. | Partial blockage. Impeller worn. | Disconnect power, clean pump intake and impeller area. Звярніцеся ў службу падтрымкі кліентаў для атрымання паслуг. |
| Помпа нечакана спыняецца. | Overheating due to low water level or blockage. Электрычная няспраўнасць. | Disconnect power, check water level and clear blockages. Allow to cool. Калі праблема не знікне, звярніцеся ў службу падтрымкі кліентаў. |
If the problem persists after attempting these solutions, please contact Sicce customer support.
7. Тэхнічныя характарыстыкі
Detailed specifications for the Sicce Ultrazero Flat Sucking Pump, Model 925607:
| Спецыфікацыя | Каштоўнасць |
|---|---|
| Марка | Січэ |
| Нумар мадэлі | 925607 |
| Max. Delivery Rate (Flow Rate) | 3000 XNUMX л/г |
| Макс. Вышыня дастаўкі | 3.1 м |
| Power Consumption (P1) | 80 Вт |
| Аперацыйная Voltage | 220-240 В / 50 Гц |
| Conductor Length (Power Cable) | 10 m (three-core, indoor and outdoor use) |
| Падключэнне ціску | 26.44 mm (3/4") AG |
| Дыяметр злучэння шланга | 20 mm (3/4") |
| Max. Solids Size | 3 мм |
| Рэшткавы ўзровень вады | Down to 2-3 mm |
| Памеры прадукту (прыблізна) | 140 mm (Diameter) x 160 mm (Height) / 5.5" x 6.3" |
| Вага прадмета | 2.6 кг (5.72 фунтаў) |
| Паплавок перамыкач | няма |
| Абарона ад перагрузкі | No (Internal thermal protection may exist, but no external reset) |
| Паходжанне | Зроблена ў Італіі |
Figure 8: Technical drawing illustrating the pump's dimensions and 3/4" GAS connection.
8. Гарантыя і падтрымка
For warranty information or technical support regarding your Sicce Ultrazero Flat Sucking Pump, please contact Sicce customer service. Keep your purchase receipt and model number (925607) handy when contacting support.
вытворца: Ebara
Марка: Січэ
For further assistance, visit the official Sicce webсайт або звярніцеся да мясцовага дыстрыбутара.