GOOLOO GP80 800A Peak SuperSafe Car Jump Starter User Manual

1. Уводзіны

Thank you for choosing the GOOLOO GP80 800A Peak SuperSafe Car Jump Starter. This portable and powerful device is designed to jump start 12V vehicles with up to 4.5L gas engines, and can also serve as a portable power bank for charging various electronic devices. Please read this manual carefully before use to ensure safe and optimal performance.

Image: The GOOLOO GP80 jump starter connected to a car battery, demonstrating its primary function.

2. Важная інфармацыя па бяспецы

Always observe the following safety precautions when using the GOOLOO GP80 jump starter:

• Не рабі immerse the unit in water or expose it to rain.
• Не рабі operate the unit if it has been severely damaged or dropped.
• Не рабі disassemble the unit. Only qualified service personnel should repair this device.
• Не рабі use the jump starter to charge non-rechargeable batteries.
• Забяспечце належную вентыляцыю падчас выкарыстання.
• Захоўваць у месцах, недаступных дзецям.
• Wear eye protection when working near batteries.
• Злучыце склamps correctly: Red to Positive (+) і Black to Negative (-). Reverse polarity can cause damage.
• Remove the jump starter from the vehicle battery within 30 seconds after the vehicle starts.

3. Змесціва ўпакоўкі

Please check the package contents upon opening. If anything is missing or damaged, contact GOOLOO customer support.

• GOOLOO GP80 Jump Starter
• Smart Jumper Clamps
• Зарадны кабель USB-C
• Кіраўніцтва карыстальніка
• Storage Case (may vary by package)

Image: The GOOLOO GP80 jump starter unit shown with its smart jumper clamps.

4. Асаблівасці і кампаненты прадукту

Familiarize yourself with the different parts of your GP80 jump starter:

• Кнопка харчавання: Turns the unit on/off and activates the flashlight.
• Індыкатар ўзроўню батарэі: LED lights showing the remaining battery capacity.
• USB Output Port (Quick Charge): Для зарадкі смартфонаў, планшэтаў і іншых прылад з падтрымкай USB.
• Уваходны/выхадны порт USB-C: For charging the jump starter itself or charging other devices.
• 12V Jump Start Port: Connects to the smart jumper clamps.
• Святлодыёдны ліхтарык: Provides illumination, with multiple modes (steady, strobe, SOS).

5. Charging the GP80 Jump Starter

Before first use, fully charge the GP80. It is recommended to recharge the unit every 3 months to maintain battery health, even if not used.

1. Connect the provided USB-C charging cable to the USB-C Input/Output port on the GP80.
2. Connect the other end of the USB-C cable to a USB wall adapter (not included) or a powered USB port.
3. The battery level indicator lights will illuminate and flash during charging. All lights will be solid when fully charged.

A full charge typically takes 3-4 hours depending on the power source.

6. Інструкцыя па эксплуатацыі

6.1. Запуск аўтамабіля ад дажджу

Ensure the GP80 is at least 50% charged before attempting to jump start a vehicle.

1. Connect the Smart Jumper Clamps: Insert the blue plug of the smart jumper clamps into the 12V Jump Start Port on the GP80. Ensure it is fully inserted.
2. Падключэнне да аўтамабільнага акумулятара:
   • Падключыце ЧЫРВОНЫ (+) clamp да плюсавай клемы аўтамабільнага акумулятара.
   • Падключыце ЧОРНЫ (-) clamp to the negative terminal of the car battery or a solid metal part of the car chassis (unpainted metal).

   Разумны клamps have indicator lights and an audible alarm for safety. Refer to the clamp's manual for specific error codes.
3. Запусціце аўтамабіль: Аднойчы склamps are correctly connected and the smart clamp indicator light is solid green, start your vehicle's engine.
4. Выдаліць Clamps: As soon as the vehicle starts, remove the smart jumper clamps from the car battery first, then disconnect the blue plug from the GP80.

Важна: Do not crank the engine for more than 3 seconds. If the vehicle does not start, wait at least 30 seconds before attempting again. Do not attempt more than 3 consecutive jump starts.

6.2. Charging Mobile Devices

The GP80 can also function as a portable power bank.

1. Connect your device's USB charging cable to either the USB Output Port (Quick Charge) or the USB-C Input/Output Port on the GP80.
2. Падключыце другі канец кабеля да мабільнай прылады.
3. The GP80 will automatically begin charging your device.

6.3. Выкарыстанне святлодыёднага ліхтарыка

The built-in LED flashlight has multiple modes for convenience.

• Press and hold the Power Button for 3 seconds to turn on the flashlight (steady mode).
• Press the Power Button once to switch to Strobe mode.
• Press the Power Button again to switch to SOS mode.
• Press the Power Button once more to turn off the flashlight.

7. Тэхнічнае абслугоўванне

Proper maintenance ensures the longevity of your GP80 jump starter.

• захоўванне: Store the unit in a cool, dry place away from direct sunlight and extreme temperatures. The ideal storage temperature is between -20°C to 60°C (-4°F to 140°F).
• Перазарадка: Recharge the unit at least once every three months to prevent deep discharge and prolong battery life.
• Уборка: Для чысткі прылады выкарыстоўвайце мяккую сухую тканіну. Не выкарыстоўвайце агрэсіўныя хімічныя рэчывы або абразіўныя матэрыялы.
• Сыход за батарэяй: Avoid fully discharging the battery frequently. Charge it when the battery indicator shows 2-3 bars.

8. Выпраўленне непаладак

9. Тэхнічныя характарыстыкі

10. Гарантыя і падтрымка

GOOLOO products come with a standard warranty. For detailed warranty information, product registration, or technical support, please visit the official GOOLOO webсайт або звярніцеся ў службу падтрымкі кліентаў. Захоўвайце чэк аб куплі як пацверджанне пакупкі.

GOOLOO Official Webсайт: www.gooloo.com

Адрас электроннай пошты службы падтрымкі: support@gooloo.com