1. Уводзіны
Welcome to the world of electric skateboarding with your new MEEPO Campus V5 Series/Envy Electric Skateboard. This manual provides essential information for the safe and optimal operation, maintenance, and care of your skateboard. Please read it thoroughly before your first ride to ensure a safe and enjoyable experience.
Figure 1: MEEPO Campus V5 Series/Envy Electric Skateboard (Top, Side, and Bottom Views)
2. Правілы бяспекі
Your safety is paramount. Electric skateboards can reach high speeds and require careful handling. Always adhere to the following safety guidelines:
- Апранайце ахоўнае рыштунак: Always wear a helmet, knee pads, elbow pads, and wrist guards.
- Check Your Board: Before each ride, inspect the board for any loose components, wheel damage, or battery issues.
- Understand Your Surroundings: Ride in safe, open areas away from traffic, pedestrians, and obstacles.
- Ведайце свае межы: Start at low speeds and gradually increase as you become more comfortable.
- Умовы надвор'я: Пазбягайце язды ў вільготных умовах, падчас моцнага дажджу або на слізкай паверхні.
- Мясцовыя законы: Be aware of and comply with all local laws and regulations regarding electric skateboards.
- Абмежаванні па ўзросце і вазе: This product is suitable for adults and teens. The maximum load capacity is 330 pounds.
3. Змесціва ўпакоўкі
Upon unboxing your MEEPO Campus V5 Series/Envy Electric Skateboard, please verify that all the following items are included:
- MEEPO Campus V5 Series/Envy Electric Skateboard (NLS3)
- Пульт дыстанцыйнага кіравання
- Зарадная прылада
- T-Tool (for adjustments)
- Spare Belts (245mm)
- USB Charging Cable for Remote
- Кіраўніцтва карыстальніка (гэты дакумент)
Малюнак 2: Уключаныя кампаненты
4. Усталёўка і зборка
4.1 Першасны агляд
Before your first ride, carefully inspect your skateboard for any signs of damage during shipping. Ensure all screws are tightened and wheels spin freely.
4.2 Зарадка акумулятара
- Connect the charger to the charging port on the skateboard.
- Падключыце зарадная прылада да стандартнай разеткі.
- The indicator light on the charger will change (e.g., red to green) when fully charged.
- Час зарадкі складае каля 2 гадзін для поўнай зарадкі.
4.3 Спалучэнне дыстанцыйнага кіравання
Your remote control should be pre-paired. If re-pairing is needed, refer to the specific instructions in the separate remote control manual or the official Meepo webсайт.
4.4 Wheel and Belt Installation/Adjustment
The NLS3 model uses belts for power transmission. Periodically check the tension and condition of these belts. If replacement is necessary, follow the steps demonstrated in the video below. Ensure the wheel is securely fastened after any adjustments or replacements.
Video: How to replace 245mm belts for NLS 3. This video demonstrates the process of removing and installing the drive belts on the MEEPO NLS3 electric skateboard, including loosening and tightening the necessary screws and properly seating the new belt.
5. Operating Your Electric Skateboard
5.1 Пачатак працы
- Turn on the skateboard and the remote control.
- Ensure the remote is connected to the board (check remote display).
- Place one foot on the board, then push off with the other foot to gain initial momentum.
- Gently push the throttle on the remote to accelerate.
5.2 Функцыі дыстанцыйнага кіравання
The N5S Display Remote allows for precise control:
- Дросель: Push forward to accelerate, pull back to brake.
- Рэжымы хуткасці: Switch between different speed modes (e.g., Beginner, Eco, Pro) to match your skill level and riding environment.
- Дысплей: Shows current speed, battery level (board and remote), and distance traveled.
5.3 Тэхніка язды
- Стойка: Find a comfortable stance with your feet positioned over the trucks for balance.
- Паварот: Lean into turns, similar to a traditional skateboard or snowboard.
- тармажэнне: Apply brakes smoothly to avoid sudden stops. Regenerative braking helps recharge the battery.
Figure 3: Proper Riding Stance
6. Тэхнічнае абслугоўванне
Regular maintenance ensures the longevity and performance of your electric skateboard.
6.1 Сыход за акумулятарам
- Зараджайце акумулятар цалкам пасля кожнага выкарыстання, асабліва калі ён захоўваецца працяглы час.
- Не перазараджайце і не разраджайце акумулятар цалкам.
- Захоўвайце дошку ў прахалодным, сухім месцы, удалечыні ад прамых сонечных прамянёў і экстрэмальных тэмператур.
6.2 Ачыстка і захоўванне
- Wipe down the board with a damp cloth after each ride to remove dirt and debris.
- Avoid using harsh chemicals or excessive water, especially near electronic components.
- Store the board indoors in a dry environment.
6.3 Belt and Wheel Maintenance
- Regularly inspect drive belts for wear, cracks, or damage. Replace them as needed (refer to Section 4.4).
- Check wheels for cuts, cracks, or excessive wear.
- Ensure wheel nuts are tightened to prevent wobbling.
- Clean bearings periodically to maintain smooth wheel rotation.
Figure 4: Wheel and Motor Assembly
7. Выпраўленне непаладак
If you encounter issues with your MEEPO electric skateboard, refer to the table below for common problems and solutions.
| праблема | Магчымая прычына | Рашэнне |
|---|---|---|
| Board not turning on | Нізкі зарад батарэі; кнопка харчавання націснута няправільна | Charge the board; Press and hold the power button firmly |
| Пульт не падключаецца | Remote battery low; Not paired; Interference | Charge remote; Re-pair remote (refer to remote manual); Move away from interference sources |
| Страта магутнасці падчас язды | Low board battery; Overheating; Loose connection | Charge board; Allow board to cool down; Check all connections |
| Unusual noises from wheels/motors | Debris in motor/belt; Worn bearings; Loose components | Clean motors/belts; Replace bearings; Tighten all screws |
| Зніжаны дыяпазон | Battery degradation; Riding style; Terrain | Ensure full charge; Ride in Eco mode; Avoid steep hills or aggressive acceleration |
8. Тэхнічныя характарыстыкі
Key technical specifications for the MEEPO Campus V5 Series/Envy Electric Skateboard (NLS3):
| Асаблівасць | Спецыфікацыя |
|---|---|
| Марка | Міпо |
| Назва мадэлі | MB0094 (NLS3) |
| Максімальная хуткасць | Up to 29 Mph (47 km/h) / 32 Mph (52 km/h) |
| Максімальная далёкасць | Да 24 міль (38 км) |
| акумулятар | 12S2P MolicelP42A, 362WH (8.4AH) |
| Час зарадкі | Approx. 2 hours (with 4.5A fast charging) |
| Рухавікі | 2 x 2519W (HB-4240) |
| ESC | Hobbywing ESC (HB-9028-36A) |
| Матэрыял калоды | Pure Bamboo + Fiberglass (8 Ply) |
| Даўжыня калоды | 38.9 цаляў (980 мм) |
| Шырыня палубы | 12.2 цаляў (254 мм) |
| Вага прадмета | 9.7 кілаграма |
| Грузападымальнасць | 330 фунта |
| Памер колы | 90 міліметра |
| Грузавікі | 8-inch RKP (Reverse Kingpin) |
| Воданепранікальнасць | IPX5 (Splash resistant, not submersible) |
Figure 5: Skateboard Components and Performance Overview
9. Гарантыя і падтрымка
9.1 Інфармацыя аб гарантыі
Your MEEPO Campus V5 Series/Envy Electric Skateboard comes with a limited warranty. Please refer to the official Meepo website or contact customer support for detailed warranty terms and conditions. The warranty period is typically 6 months from the date of purchase.
9.2 Падтрымка кліентаў
For any questions, technical assistance, or warranty claims, please contact Meepo customer support:
- Афіцыйны Webсайт: www.meepoboard.com
- электронная пошта: info@meepoboard.com
- Жывы чат: Available on the official webсайт.
- Адрас: G/f Hang Wai Indctmo 6 Kin Tai St Tuen Mun Nt Hong Kong
Meepo is committed to providing high-quality products and excellent customer service. Your satisfaction is our priority.