LIGHTBAUM Adjustable LED Flashlight Instruction Manual

LIGHTBAUM Adjustable LED Flashlight

СПЕЦЫФІКАЦЫЯ

ЭТАПЫ ЗБОРКІ

1. 1. Remove the main lighting unit from the cane clip
2.  Find the arrow mark beside the small window.Turn the battery holder as illustrated, and the stopper willdisappear from the window
3. Pull out the battery holder case with light from light hood.
4. Separate LED bulb and batteries from the battery holder case as illustrated.
5. Push side bar to remove used batteries, and replace with new batteries.
6. Place the LED light with new batteries into battery holder and push the unit up to bottom and turn backward until the stopper Is locked into the window securely.
7. Slid the LED light unit into clip.
8. Push LED light to test lighting function.
9. Slid the clip to walking cane and adjust to proper lighting angle.
10. If the light does not work property after batteries are changed, please repeat steps 1 to 5 and remove the light unit from battery holder, and use screw driver of pin to push the small steel piece under the most bottom battery, repeat steps 6 to 9 and put the

LED light unit back to light holder, and the light should work property now.